Description
Dig-Quad v4 is here!
Revision v4r1 is a completely reworked board, it keeps what the Dig-Quad is known for (four channels, 5–24V and serious current) and rebuilds nearly everything around it.
New power stage: 24V issue fixed
A new DC-DC converter design fixes the 24V issue of the previous revision, where a specific IC could fail at 24V. The supported input range is unchanged: anything from 5V to 24V.
Onboard microphone
The included QuinLED-ESP32 now carries a digital PDM microphone. Strictly speaking that’s an ESP32 change rather than a Dig-Quad one, but because it always comes included, every Dig-Quad v4 can run sound-reactive effects out of the box.
Relay channel replaces the 5th output
Instead of the v3’s extra 5th output there’s now a relay channel built around a load switch: a 5V trigger output for an external relay (shared with Q1, see the pinout guide), on a smaller connector with a pigtail cable included. The VEXT terminal goes from 3 to 2 pins and still accepts 5–24V.
Upgraded, colour-coded main input
The main input terminals are slightly higher rated and now colour-coded (red for positive, black for negative/GND), so wiring the supply the wrong way round is much harder.
Tougher data outputs
An improved level-shifter circuit adds extra hardware ESD protection on the data lines, and the resistor-switcher switches are now shared.
I²C port + single-board Ethernet
A new I²C port (Stemma QT / JST-SH 1.0mm) makes it easy to plug in sensors or a small display. The Ethernet option is now a single board instead of a stacked one, with its lip pointing up.








Jerry (verified owner) –
Could hardly wait. First order. Now the wait !
Jerry Aycock
justin collins (verified owner) –
The Dig-Quad worked wonderfully for me. I have it running 4 “yard props” for my Christmas display.
DrZzs –
fantastic
Glad to hear it
thanks for the feedback!
Harrison Tran (verified owner) –
Hello, are there any project boxes or cases you would recommend for this controller?
DrZzs –
I’ve used a soap box from Walmart. fits nice, only costs $1. Someone made one on Thingiverse if you have a 3d printer: https://www.thingiverse.com/thing:4690991
Jack Heller (verified owner) –
Easy and AMAZING!!!